Ricoh AP2610N - Manual (Page 386)

Appendix
96
7
Protocol
Use the set command to allow/prevent remote access for each protocol.
msh> set protocol {up | down}
*1 Available when the 1394 Interface Unit Type 4510 is installed.
Note
❒ If you prohibit remote access using TCP/IP and then log out, you cannot use
remote access. If this was a mistake, you can use the control panel to allow ac-
cess by TCP/IP.
❒ When you prevent access via TCP/IP, you are also prevented from using
ip1394, lpr, ftp, rsh, diprint, web, snmp and ipp.
Printer status
The following commands can be used to get information about the current status
of the printer.
msh> command
Note
❒ More information about any print job is displayed when the ID number is
added after the prnlog command.
Protocol
appletalk
tcpip
netware
netbeui
scsiprint *1
ip1394 *1
lpr
ftp
rsh
diprint
web
snmp
ipp
“up” means active and “down” means
inactive.
Command Information that is displayed
status Status of printer.
Information about the print jobs.
info Information about the paper tray, output tray,
printer language of printer.
prnlog [ID] Lists the last 16 print jobs.