Ricoh AP2610N - Manual (Page 148)

Paper and Other Media
46
3
BBBB
Load envelopes until they stop,
with the print side up and the
sides of the flaps on the left as
shown below.
Important
❒ Confirm that the envelope flaps
are securely folded down, and
that there is no air inside the en-
velopes.
Note
❒ Confirm that the top of the stack
is not higher than the limit mark
on the side guides.
❒ Do not push the stack of enve-
lopes with too much force.
CCCC
Slide the side guides against the
edge of the envelope stack.
Note
❒ Confirm that the edges of enve-
lopes fit under the side guides.
DDDD
Set the envelope size and feed di-
rection using the control panel as
follows:
A Press {{{{Menu}}}}.
“Menu” appears on the panel
display.
B Press {{{{U U U U}}}} or {{{{T T T T}}}} to display
“Paper Input” menu.
C Press {{{{Enter #}}}}.
The following message appears.
D Press {{{{Enter #}}}}.
ZGDY411J
Menu:
Paper Input
Paper Input:
Bypass Size
Enter Form Feed
Job Reset
On Line
Escape
Menu
Power Error Data In
Enter Form Feed
Job Reset
On Line
Escape
Menu
Power Error Data In