Ricoh AP2610N - Manual (Page 40)

Installing Options
26
2
DDDD
Use a coin to remove the two
screws.
Note
❒ These screws are used again in
step M .
EEEE
Pull out the handle of the control-
ler board.
FFFF
Pull the handle and slide the con-
troller board out.
GGGG
Place the controller board on a flat
surface.
HHHH
Use a coin to remove the two
screws, and then remove the cov-
er.
Note
❒ These screws are used again in
step J .
IIII
Attach the 1394 Interface Unit to
the controller board.
Insert the end of the 1394 Interface
Unit into the opening (
A), and
then push down until it clicks (
B).
ZGDX280J
ZGDX370J
ZGDX260J
ZGDX410J
ZGDX421J
ZGDX430J