Ricoh AP2610N - Manual (Page 394)

Appendix
104
7
❖ ❖ ❖ ❖ Job Spool Setting
msh> spoolsw spool {on | off}
Note
❒ Specify "on" to enable the job spool function or "off" to disable it.
❖ ❖ ❖ ❖ Clearing Spool Job
If the printer is turned off accidentally during a spool job, you can specify
whether the job will be reprinted when the printer is turned back on.
msh> spoolsw clearjob {on |off}
❖ ❖ ❖ ❖ Protocol Configuration
To change the protocol settings, use the following command. You can specify
the setting for [lpr] or [ipp].
• lpr
msh> spoolsw lpr {on |off}
• ipp
msh> spoolsw ipp {on |off}
Changing the Host Name
Use the hostname command to change the printer name.
msh> hostname [interface_name ] printer_name
*1 If you did not enter the interface name, it will be automatically set to the Ethernet in-
terface.
*2 If you install the 802.11b Interface Unit Type A, you can set the command.
*3 If you install the 1394 Interface Unit Type 4510, you can set the command.
Note
❒ Enter the printer name using up to 13 characters.
❒ You cannot use a printer name starting with RNP or rnp.
❒ The Ethernet interface and IEEE 802.11b interface will have the same printer
name.
interface name Interface to be configured
ether Ethernet interface *1
wlan *2 IEEE 802.11b interface
ip1394 *3 IEEE 1394 interface