Ricoh AP2610N - Manual (Page 397)

Remote Maintenance by telnet
107
7
Changing the password
Use the passwd command to change the remote maintenance password.
Important
❒ Be sure not to forget or lose the password.
Note
❒ The default password is “password”.
AAAA
Type “passwd”.
msh> passwd
BBBB
Type the current password.
Old password:
CCCC
Type the new password.
New password:
Note
❒ The password must consist of 3 to 8 alphanumeric characters and symbols.
Upper and lower case characters are considered unique. For example, R is
different from r.
❒ The password is the same as that used in the configuration of the Network
Interface Board using a Web Browser and that used in the NIB Setup Tool.
If you change a password from telnet, the other passwords are also
changed.
DDDD
Type the new password once again.
Retype new password: