Ricoh AP2610N - Manual (Page 391)

Remote Maintenance by telnet
101
7
SMB
Use the smb command to configure or delete the computer name or workgroup
name for NetBEUI.
msh> smb parameter
ROUTE
Use the route command to control the routing table.
This command allows you to configure and display routing information. You
can change the network configuration from remote PCs using this command.
Note
❒ The maximum number of routing tables are 16.
*1 IP address
Parameter Settings
comp Your computer name consisting of up to 13 characters
group Workgroup name consisting of up to 15 characters
comment Comment consisting of up to 31 characters
clear comp Clears the computer name
clear group Clears the Workgroup name
clear comment Clears comment
Commands Topics of setting
route add {host | net} desti-
nation
*1 gateway *1
Adds a host/network route to “destination”, and a gateway ad-
dress to “gateway” in the table. Host becomes the default setting.
route delete {host | net}
destination
*1
Deletes a host/network route from the table. Host becomes the
default setting.
route get {destination *1 } Displays only route information corresponding to a specified
destination. When the destination is unspecified, all routing in-
formation is displayed.
route active {host | net} des-
tination
*1 on/off
You can turn the specified destination on or off. Host becomes
the default setting.
route add default gateway
*1
You can set the default gateway address.
route flush Deletes all routing information.