Ricoh AP2610N - Manual (Page 392)

Appendix
102
7
SLP
Use this command to configure SLP settings.
You can search the NetWare server using SLP in the PureIP environment of
NetWare5/5.1. To use the slp command, you can configure the value of TTL
which can be used by the SLP multi-cast-packet.
Note
❒ The default value of TTL is “1”. A search is executed only within a local seg-
ment. If the router does not support multi-cast, the settings are not available
even if the TTL value is increased.
❒ The acceptable TTL value is 1 - 255.
msh> slp ttl {1 - 255}
Setting IEEE 802.11b
To make setting for IEEE 802.11b, use the wiconfig command.
Limitation
❒ You can make settings when installing the optional 802.11b Interface Unit.
❖ ❖ ❖ ❖ View settings
The IEEE 802.11b settings are displayed.
msh> wiconfig
The IEEE 802.11b card information is displayed.
msh> wiconfig cardinfo
Note
❒ If the IEEE 802.11b interface is not working correctly, the IEEE 802.11b card
information is not displayed.
❖ ❖ ❖ ❖ Configuration
Parameter Value to be configured
mode [ap|adhoc] You can set infrastructure mode (ap) or ad
hoc mode (adhoc).
The default is ad hoc mode.
ssid ID value You can set for SSID in infrastructure mode.
The characters that can be used are ASCII
0x20-0x7e (32 bytes).
A SSID value is set automatically to the near-
est access point if the setting has not been
made.
If the setting has not been made for ad hoc
mode, the same value as for infrastructure
mode or an "ASSID" value is set automatical-
ly if the setting has not been made.