Ricoh AP2610N - Manual (Page 372)

Appendix
82
7
EEEE
Select [Property Sheet], and then click [OK].
TCP/IP
A Click the [General] tab, and then type the device name into the [Device
Name] box and comment into the [Comment] box.
• In the [Device Name] box, type the name of the printer in under 13 char-
acters. The factory default name consists of "RNP" and the last 3 bytes
of the MAC address on the Network Interface Board. For example,
when the MAC address is 00:00:74:62:7D:D5, the factory default name is
"RNP627DD5". No name of 9 characters is permitted if the prefix is
"RNP". Also, when DHCP is selected as an IP address setting, the
number of characters is limited to 13 characters.
• In the [Comment] box, type any comment on printers in under 31 charac-
ters.
NetBEUI
A Click the [General] tab, and then type the comment into the [Comment]
box.
In the [Comment] box, type any comment on printers in under 31 characters.
B Click the [NetBEUI] tab.
C Type the computer name into the [Computer Name] box.
• In the [Computer Name] box, type the name that helps you to identify
printers using the NetBEUI protocol. The factory default name consists
of "RNP" and the last 3 bytes of the MAC address on the Network Inter-
face Board. For example, when the MAC address is 00:00:74:62:7D:D5,
the factory default name is "RNP627DD5". A maximum of 13 characters
consisting of uppercase English letters, numeric, or symbols (except
"*+,/:;<=>?[\]|. and space) can be used. No name is permitted if the
prefix is "RNP". You must avoid the duplication of the same name on a
network.
• In the [Comment] box, type any comment on printers in under 31 charac-
ters.
FFFF
Click [OK].
The NIB Setup Tool exits, and the setting is transmitted to the printer.
GGGG
Exit SmartNetMonitor for Admin.