Ricoh AP2610N - Manual (Page 223)

Maintenance Menu
121
6
EEEE
Press
{{{{Enter #}}}}.
One of the following messages appears on the panel display.
Note
❒ If "WL.LAN Signal" is not displayed, "IEEE 802.11b" has not been selected
for "LAN Type" in "Network Setup" of the Host Interface menu. Select
"IEEE 802.11b" for "LAN Type", and then check the "WL.LAN Signal" in
the Maintenance menu again.
❒ If "Ad hoc" in "Comm. Mode" of "IEEE 802.11b" in the Host Interface menu
is selected, you cannot check the signal. Select "Infrastructure" and then
check it again.
❒ Every time you press {{{{Enter #}}}}, the signal is updated.
❒ The signal is indicated as "Good" if the signal strength is 76-100%, "Fair" if
the strength is 41-75%, "Poor" if the strength is 21-40%, and "Unavailable"
if the strength is 0-20%. If the signal is unstable or unavailable, remove ob-
stacles or move the printer to a place where the signal can be received.
❒ Using wireless devices or microwave sources near the printer might affect
the signal.
FFFF
Press
{{{{Escape}}}}.
WL.LAN Signal
Good 100%
WL.LAN Signal
Fair 50%
WL.LAN Signal
Poor 30%
WL.LAN Signal
Unavailable 18%