Omega Vehicle Security OMP-MODL - Manual (Page 11)

2... OMP-MODL System Base
Using the OMP-MODL 2-2
unit. As modules are added to the stack, the connectors must be aligned and
plugged together as the modules slide together. Four side retaining screws are then
installed into the sides to securely hold the assembly together.
Top Plate
A flat metal plate is provided to cover the top end of the module stack in
units not equipped with the ML-DISP Display and User button module (Refer
to the ML-DISP module in Chapter 3). The top plate fits into a recess at the
top of the unit and is fastened in place with 4 screws.
Bottom Plate / Mounting
A bottom plate is provided to cover the bottom end of the module stack as
well as provide means to mount the logger to a surface. Additionally, in
systems utilizing the Battery Pack (P/N: ML-BATT) the bottom plate is an
integral part of the Battery Pack and holds the batteries as well. The ML-
BATT is described in Chapter 3.
Mounting is done by fastening the unit to a surface with round head screws
through the keyhole slots and optionally locking the unit in place with the
addition of another anchor screw (Figure 2... -2)
To mount the unit, remove the bottom plate from the logger by removing the
4 side retaining screws in the side of the plate, then use the plate as a
template to mark the screw hole locations. The bottom plate can then be
mounted on the screws. If desired, 2 locking screws can be added in the
bottom holes to securely hold the logger and prevent it from being slid up
and off of the keyhole screws.
Slip the logger back into the bottom plate and install the 4 side screws.
ML003
ANCHOR
SCREWS
KEYHOLE SLOTS
Figure 2... -2: Bottom Plate / Hanger