Omega Vehicle Security OMP-MODL - Manual (Page 218)

11.. . A PPENDIX A: M ASTER I CON F ILE R EFERENCE
U SING T HE OMP-MODL 11-56
ICON CONFIGURATION DIALOG BOX:
CONFIGURATION OPTIONS:
Icon Name: Specify the label for the icon. This name will show directly under the icon
within the Program Net.
Input Name: In this box, HyperNet displays the Output Name of the icon connected to
this icon’s Input. The Output Name can be changed in the other icon’s
dialog.
Output after __ Samples: Specify the number of input readings to analyze before
outputting the maximum value in the group.
Output current Value upon disable: Check this box to force an output of the current
Maximum Value at any time that the icon is disabled. If this box is not
checked, upon receipt of a disable signal, the Maximum calculation will be
momentarily suspended until the icon is re-enabled and no in-process value
will be output.
For example, if a Maximum is to be calculated over 10 samples but only 7
have been analyzed and the icon is disabled, the 7 sample Maximum Value
will be output and the Maximum Value detection will be suspended until re-
enabled. Upon re-enable, the detection will continue and after 3 more
samples are received, the 10 sample Maximum will be output (unless the
following check box is checked)
Clear Sample Count and Value upon Enable: Check this box to force a reset of the
Maximum Value as well as the Sample count used used for the calculation
upon receipt of an Enable signal.
If this box is not checked, upon receipt of an Enable signal, the Maximum
analysis will proceed from its suspended state (that it entered when it was
disabled).
Units: Provides a text box for User entry of a units label that will be shown at the
output from this icon.
Output Name: Specify the label for the Output. This name will show directly
under the Output terminal within the Program Net.