Omega Vehicle Security OMP-MODL - Manual (Page 40)

3... I NTERFACE M ODULES
U SING T HE OMP-MODL 3-16
LOW is displayed, download any desired data memory, then
replace the lithium cell per the instructions in Appendix D.
R ETURN TO T OP M ENU
Press SELECT to return to the Top Menu display. Press
NEXT to cycle through this level’s menu selections again.
D ISPLAY P ROBE I CON V ALUES
During the construction of a Program Net within HyperNet, the
User can opt to connect Probe Point icons to various nodes
throughout the net. These Probe Point icons allow the User to
view the current values on the nodes to which they are
connected. (Program Net development is described in Chapter 7
and details on the Probe Point icon are included in Appendix A.)
One of the ways that the Probe Point values can be viewed is via
the OMP-MODL front panel LCD, as follows:
FYI: Probe Point is used for the icon name as
connecting these icons to a node on a Net is
somewhat analogous to putting a test meter probe
on the Net nodes and reading a value.
From the Top Menu, pressing the NEXT button twice will
advance the LCD to Display Probe Icon Values. Pressing
SELECT while Display Probe icon Values is on the LCD will shift
the display to a level containing the actual Probe Point values.
The top line of this display is the Probe icon Name assigned to
the icon during construction of the net and the second line is the
value and units.
Repetitively pressing NEXT will step the display through all of the
Probe icons previously programmed into the Program Net. To
return to the Top Menu, press SELECT when Return to Top
Menu is displayed.
Displayed Probe icon values will be updated whenever the net
node is updated. If the OMP-MODL is Stopped (ie not executing
the net), the last calculated node value will be displayed.
TIP: Displaying Probe icon Values while the OMP-MODL
is enabled will slow down the execution of the net. For
higher speed data logging applications (eg sub-second
sampling rates), faster performance can be achieved by
leaving the LCD in a mode where it is not displaying the
time/date, battery state of charge, remaining memory,
Probe icons, Memory Icons , or Net Values,
D ISPLAY M EMORY I CON V ALUES
In addition to display of Probe icon values (previously described),
the last value stored to any Memory icon within the executing
Program Net can also be displayed on the LCD.
From the Top Menu, pressing the NEXT button three times will
advance the LCD to Display Memory Icon Values. Pressing
SELECT while Display Memory Icon Values is on the LCD will
shift the display to a level containing the actual last logged
values. The top line of this display is the Memory Icon Name