Omega Vehicle Security OMP-MODL - Manual (Page 143)

9... H YPER P LOT ™ G RAPHIC D ATA D ISPLAY
U SING THE OMP-MODL 9-2
From HyperComm...
After data has been downloaded from a OMP-MODL to a OMP-MODL
Download file (*.HLD) on the PC, the data can be immediately viewed with
HyperPlot. After the Download file has been saved to PC disk, a Memory
icon will display overlaying the PC graphic in the HyperComm Window.
Double-clicking on this Memory icon will immediately launch HyperPlot. The
first seven channels of data contained within the just Downloaded file will be
automatically plotted with auto-scaled time and magnitude axis.
From Post-Processing Window
For general use, HyperPlot can be launched from the Post-Processing
window of HyperWare. Click on the Post-Processing button from the
HyperComm Window and HyperWare will change to the Post-Processing
window.
Clicking on the Launch HyperPlot button opens the HyperPlot window, at
which time a OMP-MODL Download file can be opened (details follow).
From a Post-Processing Net
If a Post-Processing Net is constructed that utilizes a Destination File icon
with a *.HLD format, HyperPlot can be launched by double-clicking on the
Destination File icon immediately after running the net. HyperPlot will start
and the first seven channels of data contained within the Destination File will
auto-scaled and plotted.
H YPER P LOT W INDOW O VERVIEW
When HyperPlot starts, the window shown in Figure 9... -1 displays (with or without
data graphed). Details on the various components of the HyperPlot window follow.
Time Axis
A horizontal axis is used for display of time. The time can be displayed in
elapsed or absolute modes with either linear or logarithmic scaling.
Data Axis
Up to seven vertical axes can be displayed on a single plot, each with
unique scaling. At the bottom of each axis is the data channel name and
units assigned during construction of the net (to the Memory icon). Upon
initial display, the axes are auto-scaled to allow the data to fit on the
workspace. If required, scaling may be expressed with scientific notation
(engineering format) and the multiplier will appear near the top of the
appropriate axis.
Slide Bars
Slide bars are displayed at the right side and the bottom of the window which
can be used for panning vertically and horizontally. Drag the slide button or
click on the arrows at each end of the slide bars to pan the display.
Figure 9...
-2: Launch
HyperPlot
button
Figure 9... -
3:
Destination
File icon