Oki 56801 User Manual
Page 63
57
26: RESTRICT ACCESS
: Select whether or not you want
restricted access. Turning on this function renders your restricted
ID registration active. Available settings are On and Off.
27: WIDTH REDUCTION
: Turning this function on enables you
to print received data at a slightly reduced width.
28: TONER SAVE
: This function allows you to select whether
to use toner saving during facsimile printing. The settings are On
and Off.
29: CNG COUNT
: This function allows you to switch to a
facsimile reception mode at a certain CNG signal quantity (1-5)
when the unit is operating in T/F.
30: 600DPI FAX TX
: This function sets whether to enable 600-
DPI read when Ex. FINE is selected for TX RESOLUTION. The
settings are On and Off.
Changing User Function Settings
1. Press the
Select Function
key.
2. Press the
9/User Prog.
One-Touch key. The display shows
1:FUNC. PROGRAMMING
.
3. Press the
YES
key. The display shows
FUNCTION NO. [ ]
.
4. Using the numeric keypad, enter the 2-digit number of the
function you want to change. This display then shows the
name of the selected function.
5. Press the
NO
key to cycle through the settings for the user
function, then press the
YES
key to confirm your selection.
The name of the next user function appears in the display.
6. Press the
Select Function
key to finish or the
Stop
key to
back out.
Note: As an example for changing the settings, see Setting
Distinctive Ring.
Setting Distinctive Ring
Note: In some countries, distinctive ring service is not available
from the local telephone company.
1. Press the
Select Function
key.
2. Press the
9/User Prog.
One-Touch key. The display shows
1:FUNC. PROGRAMMING
.
3. Press the
YES
key. The display shows
FUNCTION NO.[ ]
.
4. Using the numeric keypad, enter 12. The display shows
12:DISTINCTIVE RING
and its current setting OFF.
5. Press the
NO
key to change the setting to SET.
SELECT
FUNCTION
USER
PROG.
9/OP
1: FUNC.PROGRAMMING
YES
SELECT
FUNCTION
USER
PROG.
9/OP
1: FUNC.PROGRAMMING
YES