Oki 56801 - Manual (Page 64)

58
6. Press the YES key. The display changes to SETUP FAX RING,
CALL FAX NUMBER NOW .
7. Using a separate telephone line, immediately dial the
number assigned to the fax machine (you must do this within
90 seconds). When your fax machine begins to ring, the
display changes to
AUTO DETECTING, RING PATTERN .
8. Your fax machine then automatically detects and remembers
its assigned ring pattern. When your fax machine has
finished programming its ring pattern, the display shows
DISTINCTIVE RING SET, RESULT=OK . After detecting and
remembering the ring pattern, the display changes to
DISTINCTIVE RING, [ON] .
9. Press the YES key to confirm your selection.
10. Press the Select Function key to finish.
Note: Occasionally, your fax machine may not be able to detect
the ring pattern on its first try. If this happens, the display
changes to
DISTINCTIVE RING SET, RESULT=NG . If this
happens, follow the above instructions again.
Dial Parameter Settings
These functions allow you to control the way your fax machine
dials telephone numbers. Refer to Dial Parameter Settings List to
determine which settings you may need to change, then refer to
“Changing Dial Parameter Settings” on page 59 to make the
change.
Note: Some settings are not available in some countries. If you
have trouble accessing a dial parameter setting listed
here, contact your dealer for assistance.
Dial Parameter Settings List
REDIAL TRIES : This function controls how many times your
fax machine automatically redials a number which is busy or
which does not answer. Available settings are from 0 to 10 tries.
(In FRE, the available settings are 1-5 tries.)
REDIAL INTERVAL : The function controls how long your fax
machine waits between each automatic redial attempt. Avail-
able settings are from 1 to 6 minutes. (In FRE, the available set-
tings are 1-12 minutes.)
DIAL TONE DETECT : This function allows your fax machine
to wait for and detect a dial tone before proceeding with dial-
ing. Available settings are on and off.
BUSY TONE DETECT : This function allows your fax machine
to detect a busy tone when sending a fax. Available settings are
on and off.
MF(TONE)/DP(PULSE) : This function controls what method
your fax machine uses for dialing. Two dialing methods are in
common use. DP, or dial pulse dialing, uses monotone pulses to
dial a number (like a rotary telephone). MF, or multi-frequency
dialing (touch-tone), uses different tones to dial a number.
Available settings are MF and DP.
MF(TONE) DURATION : If your fax machine is set to tone dial-
ing, this function controls the duration of the tones used for