Teledyne 6600 User Manual
Page 52
3 Operation
Model 6600
3-28 Part I
Teledyne Analytical Instruments
Anlz indicates that the analyzer is in the Analyze mode. If there is an * before
the
Anlz, it indicates that the range is linearized.
1.95 ppm SO2
R1:Ø —10 *Anlz
If the concentration detected is overrange, the first line of the display blinks
continuously.
3.8
Programming
CAUTION: The programming functions of the Set Range and
Curve Algorithm screens are configured at the facto-
ry to the users application specification. These func-
tions should only be reprogrammed by trained,
qualified personnel.
To program, you must:
1. Enter the password, if you are using the analyzer’s password
protection capability.
2. Connect a computer or computer terminal capable of sending an
RS-232 signal to the analyzer RS-232 connector. (See chapter 2
Installation for details). Send the rp command to the analyzer.
3. Enter the System menu.
DIG_FILT SELF-TEST
PWD LOGOUT MORE
Use the UP/DOWN switch to blink
MORE, then Enter.
AUTOCAL HMGNZR HOLD
CAL-HOLD-TIMER MORE
Select MORE and ENTER one more time
ALGORITHM
APPLICATION
MODEL OUTPUT: 4MA
Now you will be able to select the APPLICATION and ALGORITHM
set-up functions.