TRENDnet TVP-224HR - Manual (Page 24)

LAN Configuration
From the main menu, navigate to Router Configuration. Click on the LAN sub menu. The LAN
screen will appear as below.
Figure 4: LAN Screen
Data - LAN Screen
TCP/IP
IP Address
IP address for the TVP-224HR, as seen from the local LAN. Use the
default value unless the address is already in use or your LAN is using
a different IP address range. In the latter case, enter an unused IP
Address from within the range used by your LAN.
Subnet Mask
The default value 255.255.255.0 is standard for small (class "C")
networks. For other networks, use the Subnet Mask for the LAN
segment to which the TVP-224HR is attached (the same value as the
PCs on that LAN segment).
DHCP Server
DHCP Server is by default, always on. The TVP-224HR will allocate
IP Addresses to PCs (DHCP clients) on your LAN when they start
up.
If you are already using a DHCP Server, this setting must be Disabled,
and the existing DHCP server must be re-configured to treat the
TVP-224HR as the default Gateway. See the following section for
further details.
The Start IP Address and Finish IP Address fields set the values
used by the DHCP server when allocating IP Addresses to DHCP
clients. This range also determines the number of DHCP clients
supported.
See the following section for further details on using DHCP.
Buttons
Save the changes Save the data on screen.
24