TRENDnet TVP-224HR - Manual (Page 98)

TVP-224HR User’s Guide
Default Username and
Password are “admin” and “123”
respectively.
Web Configuration of Internet Access
Internet Access / DHCP Client
3. Select “Yes”
4. Click on “Save”
Router Configuration / Dynamic DNS
5. Select “Enable”
6. Enter Server Name, Host Name,
User Name, Password
7. Click on “Save”
98
Web Configuration of Dial Plan
Telnet (from a PC in same
Segment )
From Windows command prompt
Enter “telnet 192.168.0.1”
Enter Username “admin”
Enter “123”
From Windows command prompt
Enter “telnet 192.168.0.1”
Enter Username “admin”
Enter “123”
net set dhcp on
.
net set ddns on
net set ddns add dyndns tvp2
username2 password2
net store
Once Internet Access is setup, you
could choose to reboot the TVP-
224HR, and then use a PC in the same
segment and with a web browser,
access theTVP-224HR:
If using the Router’s DHCP Server,
make sure the routers DHCP Server is
on and that the configuring PC is DHCP
Client enabled.
If you would like your PC to have a
Fixed IP, Make sure that the IP does
not conflict with the range of IP’s
allocated by the TVP-224HR’s DHCP
Server.
If you are trying to access the TVP-
224HR from a PC in the same segment
as the TVP-224HR (LAN), Open your
browser and enter
a. Enter 192.168.0.1
If you would like to access the TVP-
221H from the WAN side, from a
remote PC with Internet Access:
b. Enter tvp1.dyndns.org
You will be prompted for Username and
Password. Default Username and
Password are “admin” and “123”
respectively.
You could then continue as below:
From the local connection, you
could continue on setting up the
dial plan. However you could
choose to reboot,
Enter “net reset”
Enter “telnet 192.168.0.1”
Enter “telnet tvp2.dyndns.org”
Enter Username “admin”
Enter “123”
Connect a PC directly to your
TVP-224HR making sure they
are in the same LAN segment.
From the windows command
prompt:
Or from a remote computer
You would then continue as
below: