TRENDnet TVP-224HR - Manual (Page 96)

TVP-224HR User’s Guide
Web Configuration of Dial Plan
Dial Plan Settings / Dial plan Table
Setup
7. Select “Add” and “Telephone
8. Enter following fields
a. Telephone Number:22
b. Hunt Group ID: 22
c. Min. Digits: 2
d. Max. Digits: 5
e. Strip Length: 2
f.
Append Prefix: none
9. Click on “OK”
Dial Plan Settings / Dial plan Table
Setup
10. Select “Add” and “HuntGroup”
96
atpm req
atpm aadd 22 2 5 22 2
atpm hadd 22 2 22
From the local connection, you
could continue on setting up the
dial plan. However you could
choose to reboot,
Once Internet Access is setup, you could
choose to reboot the TVP-224HR, and
then use a PC in the same segment and
with a web browser, access theTVP-
224HR:
If using the Router’s DHCP Server, make
sure the routers DHCP Server is on and
that the configuring PC is DHCP Client
enabled.
If you would like your PC to have a Fixed
IP, Make sure that the IP does not
conflict with the range of IP’s allocated by
the TVP-224HR’s DHCP Server.
If you are trying to access the TVP-
224HR from a PC in the same segment
as the TVP-224HR (LAN), Open your
browser and enter
1. Enter
192.168.0.1
If you would like to access the TVP-221H
from the WAN side, from a remote PC
with Internet Access:
2. Enter tvp2.dyndns.org
You will be prompted for Username and
Password. Default Username and
Password are “admin” and “123”
respectively.
You could then continue as below:
Enter “net reset”
Enter “telnet 192.168.0.1”
Enter “telnet
tvp1.dyndns.org”
Enter Username “admin”
Enter “123”
Connect your PC directly to
your TVP-224HR making sure
they are in the same LAN
segment. From the windows
command prompt:
Or from a remote computer
You would then continue as
below: