TRENDnet TVP-224HR - Manual (Page 70)

TVP-224HR User’s Guide
70
1. Gate Keeper Mode: The default setting is off. This field is to select the
co-operation mode with some other gatekeeper(s). Three options are
available:
i. Off: Disables gatekeeper co-operation,
ii. Auto: Enables auto-discovery of the gatekeeper
iii. Manual: Enables gatekeeper co-operation in manual
operation (the gatekeeper address must be properly
assigned).
The following fields must be filled in when Gate Keeper Mode is set to either
auto or manual.
2. Gate Keeper Address: Specify the gatekeeper address when configured
to manual mode. When auto mode is desired, this field should be set to
auto
3. Allow Calls Without Gate Keeper: This field is to inform the H.323
stack to allow calls when the endpoint is not registered with a gatekeeper.
4. Registration Type: This field is to set the endpoint registration type.
This specifies how the endpoint will register itself with the gatekeeper.
5. Max Registration Retries: This field is to control how many registration
attempts will be made before the endpoint considers itself to have failed
registration.
6. Time To Live:
7. Endpoint Prefix: This command is used to set the H.323 prefix that the
TVP-224HR uses when registering to an H.323 gatekeeper.
8. Terminal ID: To specify GW’s ID.