TRENDnet TVP-224HR - Manual (Page 53)

TVP-224HR User’s Guide
53
Figure 27: Remote Administration Screen
Data - Remote Administration Screen
Information
Information
To establish a connection from the Internet:
6. Enable Remote Administration and configure this screen.
7. From a remote location, start your Browser.
8. In the "Address" or "Location" field, enter "HTTPS//" (NOT
"HTTP//"), the Internet IP address of this device (NOT the
LAN IP address), and the port number, as follows:
HTTPS://ip_address:port_number
Where:
ip address
is the Internet IP address of this device.
port number
is the port number assigned on this screen.
9. You should then be prompted for the password for this device.
(You must assign a password!)
Settings
HTTP
Check this to allow web administration/management via the Internet.
(To connect, see above).
If Disabled, this device will ignore management connection attempts
from the Internet.
Telnet
Check this to allow Telnet administration/management via the
Internet. (To connect, see above).
If Disabled, this device will ignore management connection attempts
from the Internet.
IP Address
To manage this device via the Internet, you need to know the IP
Address of this device, as seen from the Internet. This IP Address is
allocated by your ISP. However, if you are using a Dynamic IP
Address, this value can change each time you connect to your ISP.
There are 2 solutions to this problem:
Have your ISP allocate you a Fixed IP address.
Use the DDNS feature (Internet menu) so you can connect using a