Zebra Technologies 160S - Manual (Page 13)

Continuous roll form paper, fanfold media, or cardstock with optional
perforations and registration holes may be used. The standard 160S
Printer and 105Se Printer with an optional reflective sensor can use
“black-mark media” (media having a black mark printed on the liner
side for use in positioning the labels).
Since print quality is affected by media and ribbon, printing speeds, and
printer operating modes, it is very important to run tests for your appli-
cations. This is especially true if you’re operating in Peel-Off mode, where
these variables combine with label size, backing content, diecut depth,
and even humidity to affect printer operation.
Warnings and Precautions
Installation
CAUTION: To ensure that the Zebra S-Series Printer has proper cool-
ing, do not place any padding or cushioning material on the back of, or
underneath, the unit.
230 VAC Operation
CAUTION: Refer to “Installation” for instructions on configuring your
printer for 230 VAC operation before connecting to a 230 VAC power
source.
Use of Shielded Cable
CAUTION: Refer to the “Interconnections” Section.
Zebra printers comply with FCC “Rules and Regulations”, Part 15, Sub-
part J, for Class A Equipment, using fully shielded data cables. Use of
unshielded cables may increase radiated emissions above the Class A
limits and is not recommended.
Zebra printers comply with international regulations governing radiated
emissions when using fully shielded data cables. Use of unshielded
cables may increase radiated emissions above the regulated limits.
1-4 Zebra S-Series User’s Guide
12