Upper transmissive media sensor 7-3, Upper 7-3, Black-mark media sensor position adjustment – Zebra Technologies 160S User Manual

Page 71: Transmissive media sensor position adjustment, Adjustments, Black mark media sensor position adjustment

Advertising
background image

Black Mark Media Sensor Position Adjustment

This sensor position requires no adjustment or calibration by the user.

Transmissive Media Sensor Position Adjustment

The transmissive media sensor senses either the “web” between labels or a hole

or notch in the media to determine the length of the label or ticket. The

factory-set position should be sufficient for any width label using media with a

web. However, if position adjustments are needed, follow these procedures be-

ginning with the upper sensor.

7-2

Zebra S-Series User’s Guide

Figure 7.1 Printhead Pressure Adjustment (105Se shown)

70

Advertising
This manual is related to the following products: