Baud rate (setting) 4-2, Data bits (setting) 4-2, Dtr/dsr data flow control (setting) 4-2 – Zebra Technologies 160S User Manual

Page 54: Error detection (setting) 4-2, Parity (setting) 4-2, Xon/xoff data flow control (setting) 4-2, Option switches, Configuration and calibration

Advertising
background image

Configuration and Calibration

Option Switches

These switches are located at the

rear of the printer above the Signal

Interface Cable Connection. See

Figure 4.2.
In the tables on the following page,

an “R” means the switch is OFF (po-

sitioned to the right), while an “L”

means the switch is ON (positioned

to the left). All switches are in the

OFF position when the printer is

shipped from the factory.

Zebra S-Series User’s Guide

4-1

Figure 4.1 Option Switches

Figure 4.2 Location of Option Switches

53

Advertising
This manual is related to the following products: