Zebra Technologies 160S - Manual (Page 51)

Sample ZPL II Label Formats
ZPL II ® is Zebra Technologies Corporation’s Zebra Programming Lan-
guage II label design language. ZPL II lets you create a wide variety of
labels from the simple to the very complex, including text, bar codes,
and graphics.
This section contains three sample label formats for you to begin ex-
perimenting with. It is not intended as an introduction to ZPL II. To
learn about ZPL II, send in the request card at the beginning of this
book for a copy of the ZPL II Programming Guide.
For each format, do the following:
1. Save the file.
2. Copy the file to the printer.
• Set-up the printer and turn the Power ON.
• Use a text editing program (ex: Windows Write or DOS Editor) and
type in the label format exactly as shown in the sample label format
shown below.
• Save the file in a directory for future use. Use the extension “ . zpl”.
• Copy the file to the Zebra S-Series Printer.
Note: Typically, computers running DOS use the “COPY” command
to send a file to the Zebra printer. For example, if your file
name is “format1.zpl” then type, “COPY FORMAT1.ZPL
COM1”.
3. Compare your results with those shown. If your printout does not look
like the one shown, confirm that the file you created is identical to the
format shown, then repeat the printing procedure. If nothing prints, re-
fer to “Installation” to make sure your system is set up correctly, other-
wise refer to “Troubleshooting.”
3-14 Zebra S-Series User’s Guide
50