System components 5-1, System considerations 5-1, Communications code (ascii) 5-1 – Zebra Technologies 160S User Manual

Page 59: Interfaces 5-1, Adjusting the print darkness, Adjusting the media rest position, Adjusting the position of the top of the label

Advertising
background image

Adjusting the Print Darkness

This procedure sets the darkness of the printing on the label. Use the

lowest setting which provides the necessary print quality.

1. Press the MODE key. PAUSE and DARKEN lights turn ON.
2. Press UP or DOWN to adjust the current setting.
3. Press the MODE key three times. The MODE lights will flash ON and

OFF to indicate that the settings have been saved in memory.

4. Press PAUSE to exit PAUSE mode. PAUSE light turns OFF.

Adjusting the Media Rest Position

This procedure sets the end-of-label position relative to the Tear-Off

Bar or Cutter.

1. Press the MODE key twice briefly. PAUSE and POSITION lights turn

ON.

2. Press UP or DOWN to adjust the current setting.
3. Press the MODE key twice briefly. The MODE lights will flash ON

and OFF to indicate that the settings have been saved in memory.

4. Press PAUSE to exit PAUSE mode. PAUSE light turns OFF.

Adjusting the Position of the Top of the Label

This procedure positions the printing on the label relative to the top

edge of the label.

1. Press the MODE twice briefly then press and hold for about five sec-

onds until the lights change. PAUSE and DARKEN and CALIBRATE

lights turn ON.

2. Press UP or DOWN to adjust the current setting.
3. Press the MODE key twice briefly. The MODE lights will flash ON

and OFF to indicate that the settings have been saved in memory.

4. Press PAUSE to exit PAUSE mode. PAUSE light turns OFF.

4-6

Zebra S-Series User’s Guide

58

Advertising
This manual is related to the following products: