Feed key self test 90, Feed key 90, Feed – Zebra Technologies R-140 User Manual
Page 100: Figure 34 on
FEED Key and PAUSE Key Self Test
1. Turn off the printer.
2. Press and hold the FEED and PAUSE keys while turning on the power.
Performing this self test temporarily resets the printer configuration to the
factory default values. These values will be active only until power is
turned off unless you save them permanently in memory.
Communications Diagnostics Test
This test is controlled from the front panel display. Refer to
. A
typical printout from this test is shown in Figure 34. Turn off the power to
exit this self test.
NOTE: This label will be inverted when printed.
Additional Printer Diagnostics
Additional diagnostic tests are available for this printer, however they are
beyond the scope of this user’s guide. Refer to the maintenance manual for
information about these additional tests.
Zebra R-140 User’s Guide 91
Figure 34