Zebra Technologies R-140 - Manual (Page 54)

Ribbon Removal
s
1. Break the ribbon as close to the ribbon take-up spindle as possible.
2. Refer to Figure 23. While holding the ribbon take-up spindle, turn the
knob (1) clockwise until it stops. This will cause the ribbon release bars
to pivot down (2), easing the spindle’s “grip” on the wound ribbon.
3. Slide the ribbon off of the ribbon take-up spindle. Once the spent
ribbon has been removed, ensure that the arrow on the knob aligns with
the indented notch in the ribbon take-up spindle (see Figure 23 inset).
4. Remove the empty core from the ribbon supply spindle.
5. Follow the ribbon loading procedure on
page 43 to load the new ribbon.
Zebra R-140 User’s Guide 45
2
1
Figure 23