Zebra Technologies R-140 - Manual (Page 97)

CANCEL Key Self Test
This self test prints a listing of the
configuration parameters currently
stored in the printer’s memory. See
Figure 31 (depending on the options
ordered, your label may look
different).
1. Turn the printer off.
2. Press and hold the CANCEL key
while turning on the power.
The configuration may be changed
either temporarily (for specific label
formats or ribbon and label stock) or
permanently (by saving the new
parameters in memory). Saving new
parameters occurs whenever a
calibration procedure is performed.
Refer to page 19 for further
information about the configuration
procedure.
88 Zebra R-140 User’s Guide
PULSE MODE START PRINT SIG
FEED MODE
ENABLED
DISABLED
RESYNCH MODE
RIBBON LOW MODE
REPRINT MODE
2000-05-17 12:27:15 TIME STAMP
RFID VERSION
PULSE MODE
FEED MODE
ENABLED
DISABLED
START PRINT SIG
RESYNCH MODE
RIBBON LOW MODE
REPRINT MODE
hfDep: Version 1 hfDep: Version 1
2000-05-17 12:27:15 TIME STAMP
RFID VERSION
1P1 1P1
4096 4096
NONE NONE
1536 1536
Figure 31