Zebra Technologies R-140 - Manual (Page 70)

Zebra R-140 User’s Guide 61
Selecting ZPL Mode
Press Display Shows Action/Explanation
ZPL MODE
Selecting ZPL Mode Press the RIGHT or LEFT BLACK OVAL
key to display other choices.
Default: ZPL II
Selections: ZPL II, ZPL
The printer will remain in the selected mode until it is changed by
this front panel instruction or by using a ZPL/ZPL II command. The
printer accepts label formats written in either ZPL or ZPL II. This
eliminates the need to rewrite any ZPL formats you already have.
Refer to the ZPL II Programming Reference Volumes I and II for
more information on the differences between ZPL and ZPL II .
Power-Up and Head Close Parameters
MEDIA POWER
UP
Media Power-Up Press the RIGHT or LEFT BLACK OVAL key
to display other choices.
Default: Feed
Selections: Feed, calibration, length, and no motion
This parameter establishes the action of the media when the
printer is turned on.
• Calibration: Recalibrates the media and ribbon sensors.
• Feed: Feeds the label to the first web.
• Length: Determines the length of the label.
• No Motion: Media does not move.
HEAD CLOSE
Head Close Press the RIGHT or LEFT BLACK OVAL key to
display other choices.
Default: Feed
Selections: Feed, calibration, length, no motion
Determines the action of the media after the printhead has been
opened and then closed.
• Calibration: Recalibrates the media and ribbon sensors.
• Feed: Feeds the label to the first web.
• Length: Determines the length of the label.
• No Motion: Media does not move.