Zebra Technologies R-140 - Manual (Page 63)

54 Zebra R-140 User’s Guide
Press Display Shows Action/Explanation
INITIALIZE CARD
Initialize Memory Card
CAUTION: Perform this operation only when it is necessary to
erase all previously stored information from the optional memory
card. Press the NEXT//SAVE key to bypass this function.
1. Press the RIGHT BLACK OVAL key to select “YES.”
If your printer is set to require a password, you will
now be prompted to enter the password. Enter the
password and then press the NEXT/SAVE key.
2. The display will ask “INITIALIZE CARD?”. Press the RIGHT
BLACK OVAL key “YES.”
3. The front panel LCD will ask “ARE YOU SURE?”.
4. Press the RIGHT BLACK OVAL key “YES” to begin initialization.
or
Press the LEFT BLACK OVAL key “NO” to cancel the request
and return to the “INITIALIZE CARD” prompt.
5. Press the SETUP/EXIT key followed by the NEXT/SAVE key.
If initialization is still in process, the front panel display
will flash back and forth between the two phrases
“CHECKING B: MEMORY” and “PRINTER IDLE.”
When initialization is complete, the printer will
automatically exit the configuration mode and the
front panel will display “PRINTER READY.”
NOTE: Depending on the amount of memory in the memory
card, initialization may take up to five minutes to
complete.
INIT FLASH MEM
Initialize Flash Memory
CAUTION: Perform this operation only when it is necessary to
erase all previously stored information from the FLASH memory.
Press the NEXT//SAVE key to bypass this function.
1. Press the RIGHT BLACK OVAL key to select “YES.”
If your printer is set to require a password, you will
now be prompted to enter the password. Enter the
password and then press the NEXT/SAVE key.
2. The display will ask “INITIALIZE FLASH?”. Press the RIGHT
BLACK OVAL key “YES.”
3. The front panel LCD will ask “ARE YOU SURE?”.
4. Press the RIGHT BLACK OVAL key “YES” to begin initialization.
or
Press the LEFT BLACK OVAL key “NO” to cancel the request
and return to the “INITIALIZE FLASH” prompt.
5. Press the SETUP/EXIT key followed by the NEXT/SAVE key.
If initialization is still in process, the front panel display
will flash back and forth between the two phrases
“CHECKING E: MEMORY” and “PRINTER IDLE.”
When initialization is complete, the printer will
automatically exit the configuration mode and the
front panel will display “PRINTER READY.”
NOTE: Depending on the amount of free FLASH memory,
initialization may take up to one minute to complete.