Printing a test label – Zebra Technologies R-140 User Manual

Page 32

Advertising
background image

Printing a Test Label

To print a test label:
19. Turn off the printer.
20. Press and hold the CANCEL key

while turning on the printer.

A configuration label, which shows the

printer’s currently stored parameters,

will print (similar to the one shown in

Figure 11).

If you encounter any problems while you are configuring or calibrating the

printer or printing a test label, refer to

Troubleshooting

, which starts on

page 79

. Otherwise, refer to

Establishing Communication on page 25

to set

up the communication parameters.

Zebra R-140 User’s Guide 23

PULSE MODE START PRINT SIG

FEED MODE

ENABLED

DISABLED

RESYNCH MODE

RIBBON LOW MODE

REPRINT MODE

2000-05-17 12:27:15 TIME STAMP

RFID VERSION

PULSE MODE

FEED MODE

ENABLED

DISABLED

START PRINT SIG

RESYNCH MODE

RIBBON LOW MODE

REPRINT MODE

hfDep: Version 1

hfDep: Version 1

2000-05-17 12:27:15 TIME STAMP

RFID VERSION

1P1

1P1

4096

4096

NONE

NONE

1536

1536

Figure 11

Advertising