Zebra Technologies R-140 - Manual (Page 75)

66 Zebra R-140 User’s Guide
Press Display Shows Action/Explanation
IP RESOLUTION*
IP Resolution Press the RIGHT or LEFT BLACK OVAL key to
display other choices.
Default: Dynamic
Selections: Dynamic, permanent
Depending on the selection, allows either the user (”permanent”)
or the server (”dynamic”) to select the IP address. For more
information, refer to ZebraNet Networking: PrintServer II
Installation and User’s Guide.
IP PROTOCOLS*
IP Protocols Press the RIGHT or LEFT BLACK OVAL key to
display other choices.
Default: All
Selections: All, gleaning only, RARP, BOOTP, DHCP,
DHCP/BOOTP
If “dynamic” was chosen in the previous parameter, this selection
determines the method(s) by which the PrinterServer will receive
the IP address from the server. For more information, refer to
ZebraNet Networking: PrintServer II Installation and User’s
Guide.
IP ADDRESS*
IP Address Press the LEFT BLACK OVAL key to move to the
next digit position, press the RIGHT BLACK OVAL key to increase
the value of the digit.
This parameter allows you to select the IP address if “permanent”
was chosen in “IP RESOLUTION.” (If “dynamic” was chosen, the
user cannot select the address.) For more information, refer to
ZebraNet Networking: PrintServer II Installation and User’s
Guide.
SUBNET MASK*
Subnet Mask Press the RIGHT or LEFT BLACK OVAL key to
display other choices.
Default: Permanent (user must set)
Selections: Dynamic (user may set, but server can assign),
permanent
This parameter selects the part of the IP address that is
considered to be part of the local network It can be reached
without going through the default gateway.
DEFAULT
GATEWAY*
Default Gateway Press the LEFT BLACK OVAL key to move
to the next digit position, press the RIGHT BLACK OVAL key to
increase the value of the digit.
This parameter allows you to select the IP address that the
network traffic is routed through if the destination address is not
part of the local network.
* Option required