Zebra Technologies R-140 - Manual (Page 74)

Zebra R-140 User’s Guide 65
Press Display Shows Action/Explanation
LCD ADJUST
LCD Display Adjustment Press the LEFT BLACK OVAL key to
decrease the value (reduce brightness), press the RIGHT BLACK
OVAL key to increase the value (increase brightness).
Range: 00 to 19
This parameter allows you to adjust the brightness of your
display if your display is difficult to read.
FORMAT
CONVERT
Format Convert Press the RIGHT or LEFT BLACK OVAL key to
display other choices.
Default: None
Selections: None, 150
→ 300, 150 → 600, 200 → 600, 300 → 600
Selects the bitmap scaling factor. The first number is the original
dots per inch (d.p.i.) value; the second, the d.p.i. to which you
would like to scale.
IDLE DISPLAY*
Idle Display Press the RIGHT or LEFT BLACK OVAL key to
display other choices.
Default: Firmware version
Selections: mm/dd/yy (24 hour), mm/dd/yy (12 hour),
dd/mm/yy (24 hour), dd/mm/yy (12 hour)
This parameter selects the LCD display options for the real time
clock (if installed).
NOTE: If the default value is not selected, pressing either BLACK
OVAL key will briefly display the firmware version of the
printer.
RTC DATE*
RTC Date Press the LEFT BLACK OVAL key to move to the
next digit position, press the RIGHT BLACK OVAL key to increase
the value of the digit.
This parameter allows you to set the date following the
convention selected in “IDLE DISPLAY.”
RTC TIME*
RTC Time Press the LEFT BLACK OVAL key to move to the
next digit position, press the RIGHT BLACK OVAL key to increase
the value of the digit.
This parameter allows you to set the time following the
convention selected in “IDLE DISPLAY.”
* Option required