Positioning the media sensors 14, Transmissive sensor 14, Transmissive 14 – Zebra Technologies R-140 User Manual
Page 24: Me dia sen sors, po si tion ing 14, Transmissive me dia sen sor 14
Advertising
Adjusting the Upper Media Sensor
Refer to Figure 6. (For clarity, not all printer parts are shown.)
1. Remove the ribbon (if it is installed).
2. Locate the upper media sensor. The upper media sensor “eye” is
directly below the adjustment screw head.
3. Slightly loosen the upper media sensor adjustment screw (Phillips
head).
4. Using the tip of the screwdriver, slide the upper sensor along the slot to
the desired position.
5. Secure the upper media sensor adjustment screw.
Zebra R-140 User’s Guide
15
Figure 6
Advertising