Zebra Technologies R-140 - Manual (Page 73)

64 Zebra R-140 User’s Guide
Press Display Shows Action/Explanation
APPLICATOR
PORT
Setting the Applicator Port Press the RIGHT or LEFT BLACK
OVAL key to display other choices.
Default: Off
Selections: Off, mode 1, mode 2, mode 3, mode 4
Determines the action of the verifier port.
• Off: The applicator port is off.
• Mode 1: Asserts the ~END_PRINT signal low while the printer
is moving the label forward.
• Mode 2: Asserts the ~END_PRINT signal high while the printer
is moving the label forward.
• Mode 3: Asserts the ~END_PRINT signal low for 20
milliseconds when a label has been completed and positioned.
Not asserted during continuous printing modes.
• Mode 4: Asserts the ~END_PRINT signal high for 20
milliseconds when a label has been completed and positioned.
Not asserted during continuous printing modes.
WEB S.
These parameters are automatically set during the calibration
procedure. They should only be changed by a qualified service
technician. Refer to the maintenance manual for more
information on these parameters.
Press the NEXT/SAVE key repeatedly to skip these parameters.
MEDIA S.
RIBBON S.
MARK S.
MARK MED S.
MEDIA LED
RIBBON LED
MARK LED