ZyXEL Communications ZyXEL Dimension ES-3024 - Manual (Page 132)

Dimension ES-3024 Ethernet Switch
21-4 Commands Introduction
Table 21-1 command summary
COMMAND DESCRIPTION
brief Displays a brief listing of packet
contents.
version Displays the RAS code and driver
versions.
view view <filename> Displays the specified text file.
wdog
switch [on|off] Turns the watchdog firmware
protection feature on or off.
cnt [value] Sets (0-34463) or displays the
current watchdog count (in 1.6 sec
units).
monitor status Displays the status of the
hardware monitor.
show Displays the hardware monitor’s
statistics.
vlimit <idx> <high> <low> Sets the maximum (<high>) or
minimum (<low>) voltage at the
specified point (<idx>).
tlimit <idx> <limit> Sets the maximum (<limit>)
temperature at the specified point
(<idx>).
flimit <bank> <idx> <limit> Sets the maximum (<limit>) fan
revs per minute (RPM) at the
specified fan (<idx>) in the
specified bank (<bank>). A “bank”
delineates a set of fans.
fanmask <bank> [<mask>] Sets the fan detection mask in the
specified bank (<bank>). Use the
mask to disable monitoring of a
fan.
vclear Clears the voltage statistics.
tclear Clears the temperature statistics.
fclear Clears the fan statistics.
clear Clears the hardware monitor
statistics.
enable [<on/off>] Enables or disables the hardware
monitor.
test Tests the hardware monitor chip.
ixe2424 lbt intlbt <port|All> [count] ixe2424 refers to the switch chip.
Performs an internal loop back test
on a specified port or all ports.
lbt extlbt <port|All> [count] Performs an external loop back
test on a specified port or all ports.