ZyXEL Communications ZyXEL Dimension ES-3024 - Manual (Page 136)

Dimension ES-3024 Ethernet Switch
21-8 Commands Introduction
Table 21-1 command summary
COMMAND DESCRIPTION
traceroute <host> [ttl] [wait] [queries] Sends ICMP packets to trace the
route of a remote host.
igmpsnoop
status Displays the IGMP group table.
querier Displays the port number of the
incoming port that received the
latest IGMP querier.
enable Turns on IGMP snooping.
disable Turns off IGMP snooping.
config save This command stores tagged IEEE
802.1Q VLAN and STP
configurations only in nonvolatile
memory. All other command
configurations are lost when you
restart the switch.
The following commands are system switch commands; all are preceded with sys sw .
COMMAND DESCRIPTION
garp status Shows the GARP timer status.
timer <join timer(ms)><leave
timer(ms)><leave all timer<ms>
Sets the GARP timer’s Join
Timer, Leave Timer and Leave
All Timer.
gvrp status Shows whether GVRP is
enabled or not.
enable Enables GVRP.
disable Disables GVRP.
qos defpri <port> [<0..7>] Sets the default ingress User
Priority for a port.
map <0..7> [<queue>] Maps a User Priority to a Traffic
Class.
vlan1q All “sys sw vlan1q” commands
relate to IEEE 802.1Q Tagged
VLAN configuration. Use “config
save” to save your configuration
changes.
port status <port> Shows a port’s VLAN
information.
defaultvid <port><vid> Sets the default VLAN ID of a
port.
accept <port> <all|tagged> Sets the type of frames that a
port accepts.