ZyXEL Communications ZyXEL Dimension ES-3024 - Manual (Page 150)

Dimension ES-3024 Ethernet Switch
23-4 IEEE 802.1Q Tagged VLAN
<leave all timer<ms>= This sets the duration of the Leave All Period timer for GVRP
in milliseconds. Each port has a single Leave All Period timer.
Leave All Timer must be larger than Leave Timer; the default
is 10000 milliseconds.
This command sets the switch’s GARP timer settings, including the join, leave and leave all timers.
Switches join VLANs by making a declaration. A declaration is made by issuing a Join message using GARP.
Declarations are withdrawn by issuing a Leave message. A Leave All message terminates all registrations. GARP
timers set declaration timeout values.
The following example sets the Join Timer to 300 milliseconds, the Leave Timer to 800 milliseconds and the Leave
All Timer to 11000 milliseconds.
Figure 23-5 GARP Timer Command Example
23.4.3 GVRP Status Command
Syntax:
ras> sys sw gvrp status
This command shows the switch’s GVRP settings.
An example is shown next.
Figure 23-6 GARP Status Command Example
23.4.4 GVRP Enable Command
Syntax:
ras> sys sw gvrp enable
This command turns on GVRP in order to propagate VLAN information beyond the switch.
23.4.5 GVRP Disable Command
Syntax:
ras> sys sw garp timer 300 800 11000
ras> sys sw gvrp status
GVRP control block status:
gvrpEnable = 1
gvrpPortEnable:
OOOOOOOOOOOOOOOOOOOOOOOOXXXX