ZyXEL Communications ZyXEL Dimension ES-3024 - Manual (Page 135)

Dimension ES-3024 Ethernet Switch
Commands Introduction 21-7
Table 21-1 command summary
COMMAND DESCRIPTION
ping <hostid> Pings a remote host.
route
status [if] Displays the routing table.
add
<dest_addr|default>[/<bits>]
<gateway> [<metric>]
Adds a route.
addiface <dest_addr|default>
[/<bits>] <gateway> [<metric>]
Adds an entry to the routing table
for the specified interface.
addprivate <dest_addr|default>
[/<bits>] <gateway> [<metric>]
Adds a private route.
drop <host addr> [/<bits>] Drops a route.
status Displays IP statistic counters.
udp status Displays the UDP status.
tcp
ceiling [value] Sets the TCP maximum round trip
time.
floor [value] Sets the TCP minimum round trip
time.
irtt [value] Sets the TCP default initial round
trip time.
kick <tcb> Drops the TCP connection of the
specified TCP Control Block.
limit [value] Sets a TCP output window limit.
mss [value] Inputs the TCP Maximum
Segment Size.
reset <tcb> Resets the TCP connection of the
specified TCP Control Block.
rtt <tcb> <value> Sets the round trip time for the
TCP control block.
status [tcb] [<interval>] Displays the TCP statistic
counters.
syndata [on|off] Turns on/off the option to send
data with the SYN packet.
trace [on|off] Turns on/off the trace for
debugging.
telnet <host> [port] Telnets to the specified host.
support Shows if TFTP is supported.
stats Displays the TFTP status.