ZyXEL Communications ZyXEL Dimension ES-3024 - Manual (Page 149)

Dimension ES-3024 Ethernet Switch
IEEE 802.1Q Tagged VLAN 23-3
Figure 23-3 Deleting Default VLAN Example
23.4 IEEE VLAN1Q Tagged VLAN Configuration Commands
These sw (switch) commands allow you to configure and monitor the IEEE 802.1Q Tagged VLAN.
23.4.1 GARP Status Command
Syntax:
ras> sys sw garp status
This command shows the switch’s GARP timer settings, including the join, leave and leave all timers.
An example is shown next.
Figure 23-4 GARP Status Command Example
23.4.2 GARP Timer Command
Syntax:
ras> sys sw garp timer timer <join timer(ms)> <leave timer(ms)>
<leave all timer<ms>
where
<join timer (ms)> = This sets the duration of the Join Period timer for GVRP in
milliseconds. Each port has a Join Period timer. The allowed
Join Time range is between 100 and 32767 milliseconds; the
default is 200 milliseconds.
<leave timer(ms)> = This sets the duration of the Leave Period timer for GVRP in
milliseconds. Each port has a single Leave Period timer. Leave
Time must be two times larger than Join Timer; the default is
600 milliseconds.
1. ras> sys sw vlan1q svlan cpu 3
2. ras> sys sw vlan1q svlan delentry 1
ras> sys sw garp status
GARP Timer Status :
Join Timer = 200 msec
Leave Timer = 600 msec
Leave All Timer = 10000 msec