ZyXEL Communications ZyXEL Dimension ES-3024 - Manual (Page 134)

Dimension ES-3024 Ethernet Switch
21-6 Commands Introduction
Table 21-1 command summary
COMMAND DESCRIPTION
setCommunity [<community>] Sets or displays the SNMP
SetRequest community.
trustedHost [<hostt>] Sets or displays the SNMP trusted
host.
trapCommunity [<community>] Sets or displays the SNMP Trap
community.
trapDest [<destination>] Sets or displays the SNMP trap
server.
disp Shows SNMP settings.
server access <telnet|ftp|web|icmp>
<enable/disable>
Enables or disables a service.
port <telnet|ftp|web> <portNo> Sets a port for a service.
secIP setEntry <index> <start-
addr> <end-addr> [[TELNET]
[FTP] [WEB] [ICMP]]
Sets a secured entry.
secIP active <index> Turns on a secured entry.
secIP inactive <index> Turns off a secured entry.
sec IP disp Shows the secured entries.
disp Shows the device’s service port
numbers and access control
settings.
exit Ends the console or telnet
session.
ip
address [addr] Displays the host IP address.
alias <iface> Sets an alias for the specified
interface.
aliasdis <0|1> Disables/enables the alias for the
specified interface.
arp status <iface> Displays an interface’s IP Address
Resolution Protocol status.
httpd debug [on|off] Enables or disables the HTTP
debug flag.
icmp
status Displays the ICMP statistics
counter.
discovery <iface> [on|off] Sets the ICMP router discovery
flag.
ifconfig [iface] [ipaddr] [broadcast
<addr> |mtu <value>|dynamic] Configures a network interface.