ACU-RITE MILLPWR Auxiliary - Manual (Page 10)

AMI Reference Manual 7
If you are not using the J2 or J4 connec-
tor on the AMI, you must wire a jumper
at this time to close the circuitry.
Otherwise, when you power on
MILLPWR
and the AMI, an emergency stop condi-
tion will automatically occur and
neither system will run.
Remote Go provides a switch input that can be used in place of the operator
pressing the
GO
key. Pins 5 and 6 (J2) are reserved for this function.
Note: The Remote Go input signal must be held for a minimum of
0.2 seconds in either ON or OFF mode in order for it to be recog-
nized by the AMI.