ACU-RITE MILLPWR Auxiliary - Manual (Page 15)

AMI with Spindle Control Reference Manual 12
Devices that are connected to auxiliary outputs 1-4 (pins 1 through 12) on the
AMI’s J18 connector are programmable (refer to Table 2). Figure 3 shows
an example of AMI output wiring that would control a pump.
All of the J18 outputs will automatically return to their default settings (refer
to Table 2) any time the Emergency Stop button on the front of the
MILLPWR
operator console is pressed, when an emergency stop input (via J4) occurs or
when the software detects another emergency stop condition.
Fig. 3