ACU-RITE MILLPWR Auxiliary - Manual (Page 6)

AMI Reference Manual 3
AMI System Overview
The following is a quick reference guide with each connectors name, the page
where its description appears, and their most common uses. Figure 1 on the next
page shows all connector locations.
There are five connectors available. Four of them are to be used for multiple
applications, while the J16 is limited to wiring an external 230V/115V AMI to a
power source. Always identify the correct connector for your particular applica-
tion and read its description in its entirety before beginning the wiring procedure.
Device Input J2 (refer to page 5):
• Monitor the position of machine guards
• Monitor the oil level of automatic lubrication systems
• Remote Go Input
Device Output J18 (refer to page 8):
• Control up to four devices (i.e., coolant pumps and rotary indexers)
• Activate external devices during hole patterns and position/drill
steps
Emergency Stop Input J4 (refer to page 13):
• Add table limit switches to the emergency stop circuitry
• Add an emergency stop button to the emergency stop circuitry
Emergency Stop Output J17 (refer to page 16):
• Add other controls to the emergency stop circuitry
Power Input J16 (refer to page 21):
• For use with 230V systems or with an alternate 115V power
source—connects AMI to a power source
Connector Descriptions