ACU-RITE MILLPWR Auxiliary User Manual
Page 12
AMI with Spindle Control Reference Manual
9
AMI Output Device Overview
MILLPWR
AMI interface allows it to control four (4) separate functions such as
mist and flood coolant, indexers,etc. There are three (3) programmable options
available when programming an AMI step:
•
PULSE - Sends a signal to a device for a programmable length of time.
(The pulse duration can not exceed 999.9 seconds).
•
ON - Sends a signal until program signals off, or at the completion of
the program.
•
OFF - Sends a signal to turn device off.
Each of the signals listed above can be set to display, or not display an
Operator Intervention Message (OIM) at the auxiliary function step.
•
NO - Will signal with no OIM. The signal is sent to the device and the
program continues to run. No operator intervention is required.
•
BEFORE - Will signal after an OIM. An OIM indicates that pressing
“GO” will activate the programmed device. Pressing “GO” causes the
signal to be sent, and the program continues to run.
•
AFTER - Will signal before an OIM. The signal is sent to the device
prior to displaying an OIM. After a signal has been sent, an OIM will
be displayed prompting the operator to press “GO” and the program
continues to run.