VEGA VEGAPULS 56 Profibus PA User Manual
Page 26
26
VEGAPULS 56 Profibus PA
0 %
75 %
100 %
;;;
;;;
;;;
;;;;;;;;;;;;;;;;;;;;
;;;;;;;;;;;;;;;;;;;;
;;;;;;;;;;;;;;;;;;;;
;;;;;;;;;;;;;;;;;;;;
;;;;;;;;;;;;;;;;;;;;
;;;;;;;;;;;;;;;;;;;;
;;;;;;;;;;;;;;;;;;;;
;;;;;;;;;;;;;;;;;;;;
;;;;;;;;;;;;;;;;;;;;
;;;;;;;;;;;;;;;;;;;;
;;;;;;;;;;;;;;;;;;;;
;;;;;;;;;;;;;;;;;;;;
;;;;;;;;;;;;;;;;;;;;
;;;;;;;;;;;;;;;;;;;;
;;;;;;;;;;;;;;;;;;;;
;;;;;;;;;;;;;;;;;;;;
;;;;;;;;;;;;;;;;;;;;
;;;;;;;;;;;;;;;;;;;;
;;;;;;;;;;;;;;;;;;;;
;;;;;;;;;;;;;;;;;;;;
;;;;;;;;;;;;;;;;;;;;
;;;;;;;;;;;;;;;;;;;;
;;;;;;;;;;;;;;;;;;;;
;;;;;;;;;;;;;;;;;;;;
;;;;;;;;;;;;;;;;;;;;
;;;;;;;;;;;;;;;;;;;;
;;;;;;;;;;;;;;;;;;;;
;;;;;;;;;;;;;;;;;;;;
;;;;;;;;;;;;;;;;;;;;
;;;
;;;
;;;
;;;
;;;
;;;
;;;
;;;;;
;;;;;
100 %
0 %
Tube flange system as bypass tube
Extended bypass tube on a vessel with turbulent
product movements
Mounting and installation
Make sure that the required upper vent hole
is on one axis with the marking hole in the
intermediate flange (polarisation direction of
the radar signals).
As an alternative to a surge pipe in the ves-
sel, a pipe antenna can be mounted outside
the vessel as a bypass tube.
When measuring in a surge or bypass tube,
the max. measuring range decreases by
5 … 20 % (e.g. DN 50: 16 m instead of 20 m
and DN 100 only 19 m instead of 20 m).
Align the sensor such that the marking hole in
the intermediate flange is on one axis with the
tube holes or tube openings. The polarisation
of the radar signal enables a considerably
stabler measurement with this alignment.
Surge pipe welded to
the tank
Surge pipe in the socket
piece
Pipe antenna systems in the tank
Vent hole
Marking
holes in the
intermedi-
ate flange
Deflector
max.
min.
Marking hole