VEGA VEGAPULS 56 Profibus PA - Manual (Page 46)

46 VEGAPULS 56 Profibus PA
• Now start VVO (restart).
Setup
The adjustment program, called in the follow-
ing VVO, gets into contact with the connected
sensor …
… and asks in which mode the adjustment
software should be used. After a few sec-
onds, the software indicates if and with which
system a connection exists.
If the following message is displayed, you
have to change the communication setting in
VVO.
• Then click to " Configuration Configuration Configuration Configuration Configuration“, point to "Pro- Pro- Pro- Pro- Pro-
gram gram gram gram gram“ and click to "Communication Communication Communication Communication Communication“.
• First click to " Pr Pr Pr Pr Profibus DP (for P ofibus DP (for P ofibus DP (for P ofibus DP (for P ofibus DP (for PA sensors A sensors A sensors A sensors A sensors“.
Then choose the Profibus card which is
installed in your PC.
The window for the bus communication set-
tings opens. 10 is preset as the address for
the Master Class 2 interface card. If partici-
pant number ten is free on your bus, you can
accept the setting. Typical values for bus
parameters have been preset. At this point,
you should set the communication param-
eters that apply to your system.
• Now click to "OK OK OK OK OK“.
The message " VVO will shut down and Win-
dows ® must be restarted“ appears.
Note: As a rule, a Windows ® restart is not
necessary.
• Click to " Bus parameters Bus parameters Bus parameters Bus parameters Bus parameters“.