VEGA VEGAPULS 56 Profibus PA - Manual (Page 47)

VEGAPULS 56 Profibus PA 47
Setup
• Click to " Planning Planning Planning Planning Planning“ and then to "OK OK OK OK OK“.
The VVO software asks again for the user
identification and then reads in all VEGA
Profibus sensors found. You now see the
VVO main menu window.
User identification
The preset user identification can be modified
at a later time in the menu "
Configuration/
Program/User access“.
Configuration
Configuration info
• Choose the menu " Configuration/Measur Configuration/Measur Configuration/Measur Configuration/Measur Configuration/Measur-----
ing system ing system ing system ing system ing system“.
You reach the menu window " Configuration
measuring system“. In this window you get
complete information on the VEGA sensors
connected to the Profibus.
Software addressing
If the DIP switch in the sensor is set to ad-
dress 126 or higher, the address can be
modified in the menu window "
Configuration
measuring system“. Enter a free address in
the field "
Sensor address“.