VEGA VEGAPULS 56 Profibus PA - Manual (Page 48)

48 VEGAPULS 56 Profibus PA
Setup
If the sensor address has been adjusted with
the DIP switch from 1 … 125, the address
number in the field "
Sensor address“ is grey
and cannot be changed at this point.
Create new measurement loop
• Choose the menu "C onfiguration/Measure-
ment loop/Modify“.
The menu window " Selection of measurement
loop - Modify meas. loop configuration“
opens.
• Here you choose the sensor to be
configured.
The measurement loops are listed in the
sequence of sensor addresses with a serial
number and any existing name.
• Choose in the window " Modify meas. loop
configuration“ the application and enter a
name for the measurement loop.
Parameter adjustment 1
In the menu " Instrument data/Parameter ad-
justment“ you carry out all important sensor
adjustments.
• Choose the menu " Instrument data/Param- Instrument data/Param- Instrument data/Param- Instrument data/Param- Instrument data/Param-
eter adjustment eter adjustment eter adjustment eter adjustment eter adjustment“ and then the sensor on
which you want to carry out the parameter
adjustment.
In the opening menu window, you now see
the measurement loop names and descrip-
tions previously entered under "
Create new
measurement loop“. If you have only
configured or connected one sensor, there
will naturally be a choice of only one sensor.